Estate Swing Manual de Instruções descarregar pdf (Página 42)

E-S 1000D Series Instruction Manual

433 Plug-in Receiver

4.5

5. Plug the red clip inside the control box into

the control board. The groove in the red clips

should snap into the guide on the 5 prong con-

nector.

(Fig 1)

6. The red power light should come on the re-

ceiver. (Fig 2)

7. Program your remotes to the receiver:

A. Press and release the LEARN1 button at the

top of the receiver board (ex 1). The learn LED

will illuminate steady (ex 2). (Fig 3)

B. Press and hold the button on the remote you

wish to program to the receiver.

C. Hold the remote button until the Learn LED

flashes and then turns off. (caution your gate

opener may be triggered during this process)

D. Repeat A through C for all additional re-

motes.

NOTES ABOUT REMOTES:

You can program up to 400 codes into the receiver. This could mean 1 button on 400 differ-

ent remotes or this could mean all 4 buttons on 100 remotes or anything in between. Some

choose to program all 4 buttons to a single receiver if they are not using multiple gates to

eliminate pressing the incorrect button on the remote. To do so follow the programming

above with each button of the remote. You can erase all programmed codes by holding

Learn 1 until the Learn LED comes ON and then turns OFF.

8. Put the cover on the receiver and secure it in place using the provided screw.

IMPORTANT: The receiver is a drip proof receiver. This means that it is designed to prevent

water from accessing the inside of the receiver when the water is moving downward with

gravity (rain for example).

DO NOT mount the receiver anyplace that water may access it from another angle. For ex-

ample: Do not mount near sprinklers. Do not mount the receiver horizontally. Do not mount

the receiver near a flat surface where water could splash upwards.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 56 57

Sem comentários

Estate Swing Manual de Instruções Página 42